alp5
Níže je uveden pouze náhled materiálu. Kliknutím na tlačítko 'Stáhnout soubor' stáhnete kompletní formátovaný materiál ve formátu PDF.
either may be used as an input or as a pass-through connection. Input specifications
apply equally to both inputs.
Unbalanced RCA Line Input This jack accepts a male RCA connector, wired for
unbalanced operation. This jack is hardwired in parallel with the balanced line inputs.
However, due to it being an unbalanced input, we do not recommended using it in
combination with either of the balanced inputs, as this will unbalance those inputs,
possibly causing degradation of the audio signal.
Voltage Selector. The correct voltage will have already been set for your region
so there is no reason to touch this selector. Only authorized Event technicians are
permitted to change the voltage. Please note that any evidence of tampering with
the voltage selector will invalidate the products warranty.
WARRANTY
VOID
IF REMOVED
BALANCED
INPUTS
-5dB
INPUT
SENSITIVITY
-20dB MAX
BALANCED
INPUTS
UNBALANCED
INPUT
On/Standby
Input Sensitivity
Voltage Selector
Power Connector
Unbalanced RCA Line Input
Balanced XLR
Line Input
Balanced 1/4” TRS Line Input
Tip - single (-)
Ring - single (+)
Sleeve - ground
Pin 3 (+)
Pin 2 (-)
Pin 1 (ground)
BEFORE OPENING
PULL MAIN PLUG
VOR DEM OFFNEN
NETZSTECKER ZIEHEN
POUR PREVENIR LES RISQUES D’INCENDE OU DE CHOC
ELECTRIQUE, EVITER D’EXPOSER CET APPAREIL A LA
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE
TO RAIN OR MOISTURE.
CAUTION
VORSICHT
AVERTISSEMENT
FUSE INSIDE INLET T4AL 250V
ALP5 BIAMPLIFIED DIRECT
F I E L D M O N I TO R S YS T E M
WWW.EVENT1.COM
■ 100V ~ 50/60Hz 40VA
■ 120V ~ 60Hz
40VA
■ 220V ~ 50Hz
40VA
■ 240V ~ 50/60Hz 40VA
Figure 2. Active Linear Phase rear panel connections and controls.
Input Sensitivity This control is used to compensate for different signal levels that
appear at the input. The control has a 20dB range; when set at maximum (MAX),
0.5V RMS input at the balanced in or 0.25V RMS at the unbalanced in will produce
full amplifier output. Note that when the signal appearing at the input is too hot, the
amplifiers may overload, causing distortion. If this occurs, attenuate (decrease) the
Input Sensitivity by turning the control counter-clockwise.
Standby Switch Push to turn the amplifiers ON; push again to activate standby
mode. When the amplifiers are ON, the green LED located on the front of the
monitor will illuminate. Note: In standby mode the mains power is still on.
Power Connector This connector accepts the detachable AC line cord. Use the
line cord supplied with your monitor, and make sure it is fully seated into the Power