alp5
Níže je uveden pouze náhled materiálu. Kliknutím na tlačítko 'Stáhnout soubor' stáhnete kompletní formátovaný materiál ve formátu PDF.
Inlet connector. For safety reasons, do not attempt to defeat the line cord’s ground
connection. The power connector also houses the mains fuse which is replaceable
by the user.
Care and Maintenance
Your Active Linear Phase monitors are simple to care for and maintain. The cabinets
are finished with a durable vinyl laminate that can be cleaned with a soft damp
cloth. Avoid touching the exposed speaker elements. Do not expose the rear panel
controls, connectors, or the speaker elements to moisture or chemicals. Do not
expose the unit to dripping or splashing liquids; objects filled with liquids should not
be placed on the unit.
Mix at reasonable levels to protect your speakers and your hearing.
Contacting Customer Service
If you experience any trouble with your Active Linear Phase monitors, please call
the Event Electronics Customer Service department. Before calling, however, we
ask that you please consult the Technical Support section of our Web site,
www.event1.com.
If you believe your Active Linear monitor is in need of repair, please contact the
Event Electronics Customer Service department to request a Return Authorization
Number (RA#). We can accept for servicing only those units that are accompanied
by an RA#. Units shipped without an RA# number will be refused.
Active Linear Phase Specifications
Low Frequency Driver
5.25” magnetically shielded mineral-filled polypropylene cone with high temperature
voice coil and damped rubber surround.
High Frequency Driver
1” magnetically shielded natural soft dome neodymium with ferrofluid-cooled voice
coil.
Frequency Response
45Hz – 39kHz; 53Hz – 19kHz, ±3dB, Ref 500Hz.
Crossover
2.6kHz active second-order asymmetrical
Studio Precision Specifications (cont.)
Sound Pressure Level (Output)
>105dB
Noise
>100dB below full output, 20kHz bandwidth, unweighted
Input Connectors
XLR and 1/4” connectors; accept balanced or unbalanced sources RCA connector;
accepts unbalanced sources
Polarity
Positive signal at + input produces outward low frequency cone displacement
Input Impedance
40kΩ balanced, 20kΩ unbalanced
Input Sensitivity
0.5V RMS input at the balanced ins or 0.25V RMS input at the unbalanced in
produces full output with Input Sensitivity control at maximum.
Input Sensitivity control range
20dB
Protection
RF interference, output current limiting, over temperature, turn-on/off transient,
subsonic filter, internal mains fuse.
Indicators
Power ON LED indicator.
Power Requirements
40VA, factory programmed for either 100V~ 50-60Hz, 120V~ 60Hz, 220~ 50Hz,
240V~ 50Hz mains.
Cabinet
5/8” vinyl-laminated MDF, internally insulated.
Dimensions
7.5” W x 10.5” H x 9” D
Weight
11.95 lds each.
Specifications subject to change without notice.
International:
RØDE Microphones.
107 Carnarvon Street
Silverwater NSW 2128 Australia
Ph: 61 2 9648 5855